38
www.cooperbussmann.com/wirelessresources
Cooper Bussmann 615M-1 Cellular Data Modem and IP Router Series Manual
Rev Version 1.0
Friendly IP Address
Specifies an IP address that is allowed to access the modem, or a wildcard IP
address of 0.0.0.0 that allows all IP addresses to access the modem. Leave the fifth
box blank (after the “/”) if specifying a specific IP, or 0.0.0.0. A subnet mask may
be entered in the fifth box. The mask indicates how many bits of the IP address to
match. The mask can be a value from 1 to 32.
Inbound Port
Sets the external port number for incoming requests. (Port Forwarding rules take
precedence over the services specified in LAN Settings | Remote Administration |
Incoming port, SSH Port, Telnet Port or SNMP Port.)
Destination IP
Address
Sets the Local Area Network Address of the device connected to the modem’s
Ethernet jack. Inbound requests will be forwarded to this IP address.
Destination Port
Sets the Local Area Network port number used when forwarding to the destination IP
address.
Add
Click Add to save the new entry.
Static Routes
Click the Static Routes tab on the Router page to open the static routing configuration page. Static routing refers to
a manual method of setting up routing between networks. The Static Routes page allows you to create static routes
and add them to the routing table, which appears at the bottom of the page.
Figure 24 Router–Static Routes
Static Routes
Route Name
Sets the alphanumeric identifier of the static route in the Static Route Table.
Destination IP
Address
Sets the IP address of the destination network.
IP Subnet Mask
Sets the subnet mask of the destination network.
Gateway
Sets PPP (this router’s wireless Internet connection), PPTP (VPN), GRE Tunnel, or the
local network IP address for the gateway to the destination network.
Gateway IP Address
The gateway IP address is only used if a local IP address was selected for the
gateway. Enter the address of the local gateway.