www.cooperbussmann.com/wirelessresources
Cooper Bussmann 5073E-T Managed Ethernet Switch User Manual
67
Rev Version 1.1
IP Security Mode
Enable or disable IP security. When security is enabled, the fields on this page
become active.
Enable Web
Management
When this checkbox is selected, any device whose IP address matches one of the
10 IP addresses in the Security IP1–P10 table (see the next section) will be given
permission to access this switch via HTTP service.
Enable Telnet
Management
When this checkbox is selected, any device whose IP address matches one of the
10 IP addresses in the Security IP1–IP10 table (see the next section) will be given
permission to access this switch via Telnet service.
Enable SNMP
Management
When this checkbox is selected, any device whose IP address matches one of the
10 IP addresses in the Security IP1–IP10 table (see the next section) will be given
permission to access this switch via SNMP service.
Apply
Click to apply the settings.
Static Table
The system allows you to assign up to ten IP addresses for access security. When IP Security Mode is enabled on
the IP Source Guard Configuration page, only these ten IP addresses will be able to access and manage the switch
through the HTTP/Telnet/SNMP service.
To set up the IP address table, click the
Static Table
tab on the IP Source Guard Configuration page. (To display
this page, choose
Security
-->
IP Source Guard
-->
Configuration
.)
NOTE Remember to choose Maintenance-->Save Configuration, and then click “Save” to save the new
configuration. Otherwise, the new configuration will be lost when the switch powers off. See “6.7.1 Save
Configuration.”
Figure 72 IP Source Guard - Static Table
Security IP 1
–
10
Enter the IP addresses that will be allowed to access and manage the switch through
the HTTP/Telnet service.
Apply
Click to apply the settings.
