www.cooperbussmann.com/wirelessresources
Cooper Bussmann 5073E-T Managed Ethernet Switch User Manual
17
Rev Version 1.1
NOTE The SFP port and copper combo port cannot function at the same time. The SFP port has a higher
priority than the copper port. If you insert the 1000 M SFP transceiver (which is connected to the remote
device via fiber cable) into the SFP port, the connection of the accompanying copper port will link down. If
you insert the 100M SFP transceiver into the SFP port (even without a fiber connection to the remote) the
connection of the accompanying copper port will link down immediately.
Follow these steps to connect the transceiver and LC cable.
1. Insert the SFP transceiver module into the SFP Mini-GBIC port. Notice that the triangle mark is on the bottom
of the module.
Figure 8 Transceiver to SFP Module
Figure 9 Transceiver Inserted
2. Insert the fiber cable of the LC connector into the transceiver.
Figure 10 LC Connector to Transceiver
3. To remove the LC connector from the transceiver, do the following:
a. Press the upper side of the LC connector to release from the transceiver, and then pull it out.
