Revised: 13/10/2015
PPPrintew
- 11 -
11 of 19
- 11 -
Printed: 14/10/2015
Fig 1: Rear of heater showing exact location of flue (shown from rear).
Installation in a Stud wall cavity.
1.
Mark the exact location of where the heater is to be located with an outline
720mm wide by 615mm high
2.
Check that location for the flue terminal conforms to the requirements of AS/NZS
5601 Location of a Flue Terminal.
3.
Cut out the plaster board and timber supports (re-position supports if necessary)
4.
Refer to figure 1, and continue as described on previous page.
5.
When completed, fit the “console cover” supplied to the heater fascia surround.
Fit to the heater body. Attach heater fascia.
