Step 1
Pull
Chrome
Extension
Out
Step 3
Step 2
Thumb
Screw
Step 4
L
o
o
se
n
Step 5
Pin
Pin
Step 6
Lock-Nut
Step 7
Pin Slot
Step 8
ASSEMBLY INSTRUCTIONS
(images may vary slightly from actual product)
Step 1
Unfold patented Quad-Pod
®
base legs.
Step 2
Place decorative Plastic Flange over Extension
Pole to cover the base. Slide pedestal pole into
base receptacle. Tighten nut to secure in place.
Slide flange over base connection.
Step 3
With collar nut loosened, pull Chrome Extension
out of Fan Pedestal.
Step 4
Assemble fan Control Panel/Motor assembly onto
Chrome Extension and tighten thumbscrew.
Step 5
Remove the Blade Cap by twisting it
CLOCKWISE while holding the metal shaft tightly.
Note: Threads are reversed.
Unscrew = Clockwise.
Step 6
Assemble Rear Grille onto Motor Housing. Rear
Grille should fit into pins on fan motor housing as
shown.
Step 7
Thread Locknut onto Motor Housing to lock Rear
Grille in place.
Step 8
Remove any protective covering over shaft before
Fan Blade Installation. Place Fan Blade onto
Motor Shaft. Notice the pin on Motor Shaft should
fit into slots of Fan Blade.
WARNING: Shock Hazard
• Use your fan only in dry environments. This fan is not intended for use in a bathroom, laundry
area, or similar locations, or near sinks, washing machines, swimming pools or other sources of
water. Never locate fan where it may fall into a bathtub or other water receptacle. Do not use in
damp environments such as flooded basements.
WARNING: Hot Surfaces
• Do not touch fan motor when in use. This motor is hot when in use; to avoid burns, do not let
bare skin touch hot surfaces.
WARNING: Fire Hazard
• Fans have arcing or sparking parts inside. Do not use near combustible materials, flammable
gases or sources of heat. DO NOT USE in areas where gasoline, paint or flammable materials
are used or stored. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock, fire, or damage to the fan.
WARNING: Electrical Shock Hazard
• Do not use with damaged cord or plug. Use with adequate electrical circuit that is up to code.
CAUTION: to Prevent Electric Shock
• This product has a polarized two prong plug (one blade is wider than the other) that must be fully
inserted in to a matching properly grounded outlet. This plug is designed to fit a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse the plug. If the plug still does not
fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
WARNING: to Reduce the Risk of Fire or Electric Shock
• Do not use this product with any solid-state speed control device.
DO NOT
operate any fan with a damaged cord or plug or after fan malfunctions, has been dropped
or damaged in any manner. Do not operate fan with a broken blade, safety cage or any visual
imperfections. Disconnect power before servicing. For repairs covered under warranty, see
warranty statement. For all other repairs contact Customer Service by telephone or email for
information and assistance.
DO NOT
run power cord under carpeting. DO NOT cover cord with throw rugs, runners or the like.
Arrange cord away from traffic area where it will not be tripped over. Avoid the use of extension
cords due to risk of fire. If an extension cord must be used, the cord must be minimum 14 AWG and
rated not less then 1875 watts. Do not use an extension cord unless the plug can be completely
inserted into its receptacle. Unplug the fan when not in use. Do not operate fan with its ventilation
obstructed.
5
4