T
i
g
ht
e
n
Step 10
Step 9
Control Panel
Oscillation Control
On/Off Speed Control
Oscillation Control Knob
On/Speed Controls
Off Control
WARRANTY
Your Coolworks fan has warranty against defects in materials and workmanship for a period of
one (1) year from the date of original purchase. Please keep your proof of purchase (receipt) for
any warranty claims. Warranty does not cover wear and tear, and damages arisen from misuse
or use not in accordance with the product instructions.
Printed in China
Step 9
Thread Blade Cap onto threaded end of Motor Shaft.
Note: Threads are reversed.
Tighten = Counter-clockwise.
Step 10
With logo upright, attach Front Grille to Rear Grille by
snapping them together. Be sure all 8 clips are secure.
Usage:
Fan Operation:
Always operate the fan in the upright position following all instructions and
recommendations listed in this manual.
Fan Location:
Place the fan in an unobstructed area of the room that will provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in
outlet. A loose connection may cause overheating and damage to the plug or fan.
Note: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other electric
appliances.
6
7
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
Cleaning:
CAUTION-Before cleaning the fan, be sure to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER. Replace front grille before fan use.
Allow fan to dry completely before use. Periodic grille cleaning with a vacuum will prevent dust build
up. The motor is sealed and does not require any further maintenance, cleaning or lubrication.
Maintenance:
The internal motor bearings are permanently lubricated at the factory and do not
require any additional lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE
FAN IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage
during storage.
Turning Fan On/Off:
Place fan on stable level surface. Plug fan into properly grounded outlet. To
start the fan, press desired speed button: 1-LOW, 2-MED, 3-HIGH. Press 0-OFF to discontinue use.
Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control Knob (located above motor housing)
down. To stop oscillation function pull Oscillation Control Knob up while the fan is in any oscillation
position.
