1
st
Issue 09/05 6
DMP026E
•
Allow 150mm clearance from contactors, switches and associated cabling.
Locate where ambient temperatures do not exceed 50°C or fall below 0°C and relative
humidity does not exceed 95% or fall below 5%, non-condensing.
Wall or DIN rail mounting
1. Select mounting location. Allow minimum 50mm clearance around controller.
2. Do the following to mount controller on a panel without DIN rail:
a. Loosen two screws securing terminal cover and remove cover.
b. Lift wall mounting bracket clip (located on top back of controller).
c. Using a No. 10 self-starting screw, install top screw.
d. Level controller.
e. Using two No. 10 self-starting screws, install bottom screws.
f. Re-install the terminal cover. (May be left off until wiring is completed.)
3. Do the following to mount controller on a DIN rail:
a. While pulling down on DIN rail locking bracket, snap controller base on a 35mm DIN
mounting rail.
b. Release DIN rail locking bracket.
Mounting Methods
Panel mounting
DIN rail mounting
Summary of Contents for DG501C
Page 32: ...1st Issue 09 05 32 DMP026E...
Page 33: ...1st Issue 09 05 33 DMP026E...