Controlli DG501C, User Manual

Page: 13 / 33

1
st
Issue 09/05 13 DMP026E
Panel mount Controller/LCD Wiring (Kit DG510)
It consists of a separate LCD and Base Unit. The two units should be wired together in the
following manner.
Note: in the present scheme terminal 1 of DG510 is on the flat cable
side.
Installation Checklist
1. If controller is part of a NCP network, verify network wiring between controller and other
devices is effected according to job wiring diagram and national and local electrical
codes.
2. Verify 24Vac power is provided from a power transformer conforming to EN 60742 and
wiring is carried out according to job wiring diagrams and with national and local
electrical codes.
3. Verify input jumpers are in correct position.
4. Verify outputs are wired according to job wiring diagram and with national and local
electrical codes.
5. Make certain current requirements of the controlled device do not exceed rating of
controller digital outputs.