4
Unidrive M200/201 Control Quick Start Guide
Issue Number: 3
1
Safety information
1.1 Warnings, Cautions and Notes
1.2 Installation and Use
The information given in this publication is derived from tests and calculations on sample products. It
is provided to assist in the correct application of the product, and is believed to correctly reflect the
behaviour of the product when operated in accordance with the instructions. The provision of this
data does not form part of any contract or undertaking. Where a statement of conformity is made with
a specific standard, the manufacturer takes all reasonable measures to ensure that its products are
in conformance. Where specific values are given these are subject to normal engineering variations
between samples of the same product. They may also be affected by the operating environment and
details of the installation arrangement.
The manufacturer accepts no liability for any consequences resulting from inappropriate, negligent or
incorrect installation of the equipment.
1.3 Enclosure
Unless stated otherwise in the installation instructions, the product is intended to be mounted in an
enclosure which prevents access except by trained and authorized personnel, and which prevents
the ingress of contamination. It is designed for use in an environment classified as pollution degree 2
in accordance with IEC 60664-1. This means that only dry, non-conducting contamination is
acceptable.
1.4 Competence of the installer
Installation should be carried out by professional installers who are familiar with the requirements for
safety and EMC. The installer is responsible for ensuring that the end product or system complies
with all the relevant laws in the country where it is to be used.
A Warning contains information which is essential for avoiding a safety hazard.
A Caution contains information which is necessary for avoiding a risk of damage to the
product or other equipment.
A
Note
contains information, which helps to ensure correct operation of the product.
WARNING
-
This warning applies to products intended to be used with variable
speed drives.
The adjustable speed drive uses high voltages and currents, carries a high level of stored
electrical energy, and is used to control mechanical plant which can cause injury.
Close attention is required to the electrical installation and the system design to avoid
hazards either in normal operation or in the event of equipment malfunction.
System design, installation, commissioning and maintenance must be carried out by
personnel who have the necessary training and experience. They must read this safety
information and the instruction manual carefully.
Failure to observe the following instructions can cause physical injury or death, or damage
to the equipment.
WARNING
CAUTION
NOTE
WARNING
