Contracor ECO-100S, Instructions Manual

Page: 27 / 140

E
N
G
L
IS
H
CONTRACOR
®
ECO-series suction blast cabinets 27
Picture 10. Viewing
window replacement
Picture 11. Window
gasket replacement
5.2.5 Window gasket replacement
Replace the window frame gasket and cabinet window opening gasket at the Àrst
sign of media leakage around the view window, or if gaskets appear damaged. Check the
gaskets when changing the view window.
Remove the viewing window and window frame per Section 5.2.4. Remove all the old
gasket material and clean the surfaces of the cabinet and window frame.
Peel off a small section of adhesive backing from the 15mm strip gasket, and stick
the gasket to the center of the top edge of the window opening as shown on Picture 11.
Peel off more backing as necessary and guide the strip around the edges of each comer,
pressing it Àrmly. Trim the gasket to Àt and press the ends down to seal.
Install the window molding in the window opening by Àtting the narrow slit of the
molding over the metal edge of the opening. The molding ends should meet in the middle of
the straight section of the opening. Molding should be compressed so the ends are tightly
sealed. Working from the front, install the view window into the wide slit of the molding.