Contracor ECO-100S, Instructions Manual

Page: 18 / 140

E
N
G
L
IS
H
CONTRACOR
®
Version 2.3 18
4.1.3 Grounding
Ground the cabinet to prevent static electricity build up. For grounding attach an
external grounded wire to the grounding lug on the cabinet skirt.
4.1.4 Electrical power connection
ATTENTION!
Be certain that all pipe Àttings and hose clamps are tight before using the
blast cabinet. Hose disconnection while under pressure could cause seri-
ous injury.
ATTENTION!
All electrical work must be carried out by a qualiÀed electrician according
to the national and local standards.
A wiring schematic is supplied with the cabinet. After wiring is completed, check the
motor rotation by momentarily turn switch on and off. The motor will slowly turn. Check
the rotation of the motor fan through the slots in the motor housing. The fan should rotate
clockwise when viewed from the fan end to the motor.
ATTENTION!
Do not look into the reclaimer exhauster outlet while the exhauster is
turning. Injury to the eye or face could occur from objects being ejected
from t he exhauster.
4.1.5 Cabinet static pressure
Cabinet static pressure must be set to match the cabinet dimensions. The pressure
inside the cabin is adjusted with the throttle valve which is located on the air & dust suction
pipe on the dust collector.
Try different settings of the throttle valve whilst blasting until the cabin visibility is
good when the exhausting fan is switched on.