17
16
Drone Compass Calibration
Step 2 Vertical calibration
Hold the drone with its camera facing down, and rotate it 360 degrees
along its horizontal axis for about 3 circles until the front light and rear
light of the drone change from flashing to solid. The front lights will be
solid red and the rear lights will be solid green. The compass calibration
is successful when the lights are no longer flashing and you are now
ready for lift off!
Attention
:
●
To fly at GPS mode, choose a open and wide space for the flight, and
make sure that the satellite number is more than 7.
●
DO NOT calibrate drone compass in an area with a strong magnetic
field, such as: A parking place or construction area with underground
reinforcement.
Gyroscope Calibration
Once drone is calibrated, set drone on a flat surface; push down both of
the control sticks to the lower left corner and release (indicated as below
photo). Once the front and rear lights are both green and flashing
rapidly, it means that gyroscope is under calibration status. When the
lights turn solid, calibration is successful.
●
The gyroscope calibration has been done in factory by default.
Gyroscope calibration is not required to be performed unless the drone
can not exit the drone initialization detection procedure while the drone
initialization detection is finished.
●
Please make sure to set the drone on a level horizontal surface when
performing calibration, failure to do this will affect the flight
performance.