15
14
Product Assembly cont.
How to Pair the Remote to the Drone
After mode selection is complete, begin the pairing process. With the
remote controller still in signal connection status,
power on your drone
.
After a beep sound the connection signal icon is shown on the LCD screen.
It means that the drone has successfully linked to the remote controller.
Pairing will need to be done every time you want to fly the drone
Remote Control Status Indicator Lights
No.
Status
Meaning
1
Indicator lights flash
quickly.
The remote controller is under signal
connection status.
2
Indicator lights flash slowly
with steady beep...beep
sound and the battery icon
“ ” on the LCD display is
flashing.
The remote controller battery is low.
3
Battery icon “ ” on LCD
display is as shown, with
steady beep...beep...beep
sound.
Battery is running out “ ”; the
drone will return when the altitude is
over 100m or the distance is over
300m.
4
Battery icon “ ” on LCD
display is as shown, with
steady long beep sound.
The Battery is low “ ”; the drone
will return when the altitude is over
15m or the distance is over 15m, or
land immediately.
5
Signal icon on LCD display
is less than two bars or not
displaying, with steady
beep...beep...beep sound.
1.The distance between the drone
and remote controller is so long that
the signal is weak.
2.The battery is removed nearly after
the drone connects to the remote
controller.
Drone Initialization Detection
After signal connection has been successful, the drone enters into
initialization detection procedure. The front and rear lights on the drone
will flash red, light green, and green alternately. Make sure that the
drone is set on a flat and level surface for the initialization detection. The
drone initialization detection takes about 8 seconds. The initialization
detection is done once the front and the rear lights glow light green and
flash alternately. Now the drone will enter compass calibration mode.
Two steps of compass calibration:
Step 1 Horizontal Calibration
When the drone's front and rear lights flash light green alternatively,
hold
the drone upright
and rotate it 360 degrees along the horizontal axis for
about 3 circles. The drone’s front and rear lights will change from flashing
light green alternatively to flashing dark green alternatively when
complete.
Drone Compass Calibration
Attention
: Make sure that the drone is set on a flat and level surface for
the initialization detection procedure to be successful.
Drone compass calibration should be done for every flight. That is to
say, if changing new battery or the battery is reinstalled, compass
calibration should be done again. Compass calibration must be
performed after successful drone initialization detection.
