Edition 07/2008 - XEOS EVOLUTION 2 - XEOS TALL CUP
NOTES TECHNIQUES - TECHNICAL DOCUMENTS - page 50
SACOME, Document CONFIDENTIEL,
Ne peut être reproduit ni communiqué sans notre accord préalable.
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.
FAULT
CAUSE
SOLUTION
7
The coffee continues to flow
and the cup overflows.
1. If the cycle is finished :
Group solenoid valve.
2. The cycle does not stop
until the selected button has
been pressed again.
1. The plunger is blocked
(dirt/connections/circuit board)
2. The flow meter is broken, change
the cap and check the presence of
magnets on the wheel.
8
The coffee is flowing too
quick, and it does not have a
creamy head to it.
1. Bad setting of the grinding
stones/dose.
2. The coffee is too hot.
1. Adjust the fineness of the ground
coffee - check that the quantity is
correct - 7gr. for one espresso.
2. Check the boiler pressure.
9
After having not dispensed
coffee for a while, the first cup
is less filled than it should be.
The gasket of relief device 12
bars is damaged
Change the relief device 12 bars
(409774)
10
Machine in stand-by
1. The safety sensor
2. The overheating thermostat
Check in the following order:
1.
GGGG
the water supply
GGGG
the electric connexions of the
sensor
GGGG
clean the safety sensor
GGGG
check the water feeding solenoid
valve (coil/plunger)
GGGG
the relays or the circuit board
2.
GGGG
the pressure switch
GGGG
the relays
GGGG
re-engage the klixon (overheating
thermostat) or change it
