5000 CT
5000 CT
This transmits a battery low signal which is acquired by the control unit in the zone where the
device has been memorised. The dedicated output is also activated (terminal 22) for 30
seconds.
To replace the battery proceed as follows:
1. Access the programming function (see paragraph 3.1 in the installation manual). In these
conditions, in fact, the control unit does not detect the sabotage alarm caused by the opening
of the sensor.
2. Open the sensor cover by pulling out the cap at the centre of the cover and removing the
fastening screw underneath.
3. Replace the battery and, if desired, check the radio transmission (SYSTEM TEST).
4. Close the cover.
5. Quit the programming function.
TECHNICAL DATA
Power supply
1 9V alkaline battery
Operation with battery charged
ca 1 year
Range of transmitter in free air
20 m
Transmission frequency
433.92 MHz
This device is warranted against all construction or operating defects for a period of 12 months of the date of manufacture
given on the warranty label on the back. If this label is missing the warranty loses its validity. The manufacturer assumes
no responsibility for anomalies or failures to the alarm device caused by transport or extraneous causes such as electric
discharge, overvoltage, mechanical impact, flooding, or due to improper installation or non compliance with the technical
data specified. The alarm has only dissuasive functions against theft.
5000IS-CT- Rev. 00 / 07 / 01
5000IS-CT- Rev. 00 / 07 / 01
This transmits a battery low signal which is acquired by the control unit in the zone where the
device has been memorised. The dedicated output is also activated (terminal 22) for 30
seconds.
To replace the battery proceed as follows:
1. Access the programming function (see paragraph 3.1 in the installation manual). In these
conditions, in fact, the control unit does not detect the sabotage alarm caused by the opening
of the sensor.
2. Open the sensor cover by pulling out the cap at the centre of the cover and removing the
fastening screw underneath.
3. Replace the battery and, if desired, check the radio transmission (SYSTEM TEST).
4. Close the cover.
5. Quit the programming function.
TECHNICAL DATA
Power supply
1 9V alkaline battery
Operation with battery charged
ca 1 year
Range of transmitter in free air
20 m
Transmission frequency
433.92 MHz
This device is warranted against all construction or operating defects for a period of 12 months of the date of manufacture
given on the warranty label on the back. If this label is missing the warranty loses its validity. The manufacturer assumes
no responsibility for anomalies or failures to the alarm device caused by transport or extraneous causes such as electric
discharge, overvoltage, mechanical impact, flooding, or due to improper installation or non compliance with the technical
data specified. The alarm has only dissuasive functions against theft.
