![Conti CAG-113 Manual Download Page 55](http://html.mh-extra.com/html/conti/cag-113/cag-113_manual_2656572055.webp)
BUILT-IN HOB
Lighter is not functioning when pushing the control switchs.
• Is the electric connection of the hob proper?
• There may be a blow-out.
• Is the lighter clean?
• Do the burners (burner, burner cap, etc.) fit properly?
Only one control switch is pushed but all lighters are functioning.
• This is not a fault. The lighter is the center of our system and all lighters function at the same time.
Lighters are functioning but heating zones are not being fired.
• Gas hose connecting to the hob may be damaged.
• Main gas cock may be closed.
• Gas tube or tank that you use may be empty.
• If you install the hob recently or replace the tube, keep the control switch one or two seconds open.
(until the gas is reached to the hob)
As soon as leaving the button, the fire was gone out.
• After firing the hob, go on pushing down the control switch for one or two seconds.
• Seal rings under the control switch get loose.
• A strong ambient air current may switch off the hob.
• Make sure that hob parts (burner cap, burner, etc.) fit properly.
Fire is going out or blowing highly when the switch is in lower position.
• A strong medium air current may switch off the hob.
• The connected injectors and the used gas should be checked properly.
Flames are blowing improperly and unevenly.
• Make sure that heating zones (burner cap and burners) and injectors are clean. Make sure of fitting
burner cap and burners properly.
Switches are heating during cooking.
• Use small cooker on hobs next to control switches. Big cooker should be put away from the switches.
Put the pan to the center of the hob; pans and pots should not align with the switches.
Yellowing is occurring on hob plate.
• If there is a section operating electrically in your hob, yellowing may occur on hob plate after
functioning of heater element available in this section. This situation is not a fault. It does not constitute a
reason for product replacement.
Metal voices are coming while the product is heating and cooling.
• This is not a fault. When the metal parts get heated, they may expand and make a sound.
Signal lamp does not operate.
• Fuse is blown; power supply may not at your product. Your product may out of order.
This device, in Europe, accords to the directives 2012/19/EU Waste Electrical and Electronic Equipment.
(WEEE) this device prior to disposing of junk and trash, the environment and human health against the
potential negative consequences need to block. Otherwise, this would be an inappropriate
waste. This symbol on the product, the product treated as household waste, electrical electronic alert is
for the delivery of waste collection facilities. The destruction process of the product must be in
accordance with local environmental regulations. To destroy the product, use it again and again for
the detailed information for recycling can be obtained from the competent departments.
Summary of Contents for CAG-113
