Contec FX-DS540-APDL-U, User Manual

Page: 37 / 91

3. Setup
30
FX-DS540-APDL-U
Power Supply Connection
This product has two methods to supply the power.
Using the attached AC adapter
Plug the AC adapter into a wall outlet, then connect the DC jack to the power plug in the main unit.
Using the UTP cable (Optional POW-CB20, POW-CBM4 are necessary.)
As the FX-DS540-APW contains a power supply separator unit, it can be powered directly from the
POW-CB20 or POW-CBM4. Power supply separator unit POW-SP20 is not used.
To supply power to the unit using a UTP cable, refer to the PW-CB20 or POW-CBM4’s instruction
manual to connect it correctly. And use UTP cable having category 5.
Using the attached AC adapter Using the UTP cable
AC adapter
HUB
*Cable length between this product and PC or HUB is less than 90m.
*1 : Optional TP-03(3m), TP-05(5m), TP-10(10m), TP-20(20m), TP-50(50m) can be used.
*2 : Optional TP-X (Cross cable and attachment which are 30cm) can be used.
UPLINK 8X 7X 6X 5X 4X 3X 2X 1X
Straight cable*1
Cross cable*2
Straight
cable*1
PC (NIC)
Enlarged figure
POW-CBM4
POW-CBM4
HUB
UTP cables are
all staraight cables*1
POWER
WLAN
LAN
POWER
WLAN
LAN
POWER
WLAN
LAN
UPLINK 8X 7X 6X 5X 4X 3X 2X 1X
A
P
HUB A
P
HUB
Figure 3.7. Power Supply Connection
CAUTION
- Do not connect any AC adapter other than the accessory. Doing so may result in a failure in the
device or an accident. Note, in particular, that the AC adapters bundled with the FX-DS540-APP
and FX-DS540-APW are different in voltage while being identical in shape.
- The power supply from the UTP cable is corresponding to the optional POW-CB20/POW-CBM4.
You cannot use the power supply unit of another company. Doing so may result in a failure in the
device or an accident.
- Do not connect the AP-side UTP cable of the POW-CBM4 to a device such as a hub as doing so
can cause a device fault or accident.
- The power supply cannot be done by the power supply separator unit POW-SP20. Doing so may
result in a failure in the device or an accident.