—
Installation
—
CPSA-PCB100 Reference Manual
—
91
—
Unlock the hook with a slotted screwdriver
There are two ways to unlock the hook using a slotted screwdriver.
Unlock it by one of the following methods.
Using the screwdriver as leverage
Insert a slotted screwdriver (the point should be smaller than 4.5mm) into a hole.
(see the figure below)
By using the screwdriver as leverage, move it upward in the direction of the arrow to unlock.
By rotating the screwdriver
Place the slotted screwdriver (the point should be smaller than 8mm) as shown in the figure.
Rotate the screwdriver 90-degree in either direction.
2
(1). With the hooks unlocked, pull the lower part of the product toward you.
(2). By lifting the product, you can easily remove it from the DIN rail.
A projection tip to support the driver
