Contec AI-1204Z-PE, Reference Manual

Page: 74 / 85

—
Appendix
—
AI-1204Z-PE Reference Manual
— 74 —
Function Specifications (2/2)
Item AI-1204ZPE
Digital input Number of input channels 4ch
Input type Unisolated input (LVTTL level positive logic)
Digital output Number of output channels 4ch
Output format Unisolated output (LVTTL level positive logic)
Bus master
section
DMA channels 1ch
Transfer bus width 64/32bit
Transfer rate 360MByte/s
Synchronization
bus section
Control output signal Selection of output signal with the software when
specifying a sync master board.
Control input signal Selection of sync factor with the software when
specifying sync slave boards.
Max. board count for
connection
16 boards including the master board
Common
section
Memory addresses Occupies 2 locations 256MByte
Connector used For analog (CN1,2,3,4) :
BNC connector B-901W1AAN03 equivalent
[mfd. By INSERT ENTERPRISE],
For digital (CN5) : 16pin pin header connector
Current consumption (Max.) 5VDC 1600mA, 12V 550mA
Operating condition 0 - 50°C, 10 - 90%RH (No condensation)
Bus specification PCI Express Base Specification Rev.2.0 x1
Physical dimensions (mm) 169.33(L) x 110.18(H)
Weight 150g
*1 Do not input voltages in excess of the maximum input voltage. Similarly, do not input voltage
exceeding 1.5 times the range being used, even if less than the maximum input voltage.
Inputting too high a voltage may cause a fault.
*2 The rated precision may not be achieved depending on the cable used.
*3 The non-linearity error means an error of approximately 0.1% occurs over the maximum range at
0°C and 50°C ambient temperature.
*4 A 6166[ADC] voltage generator was used for measurements.