GSM-PRO2
- 27 -
Configure the extension(s) for the module by clicking IO-
>Extensions. Click the ‘Add’ button to add a module.
Fill the bus address as adjusted on the extension and choose the type of module. Click ‘Add’ and the module
appears in the list. Repeat this step for the number of extensions connected to the module.
Each added module can be configured with a module name and up to 10 users who have access to the module
in case of outputs, or receive messages in case of inputs.
NOTE
: Failure on Extensions are sent to the users in the general message tab.
10.2
GSM-PRO-4DO
The 4DO has 4 CO outputs. The following items can be configured with the software for each output:
•
Output name.
•
Confirmation message for falling and rising flank.
•
User defined instructions to change the status on or off or activate a one-shot.
To change the output status by a default message SMS:
WDOnxEa
where n is the output number, x the status
and a the bus address.
To activate a one-shot by a default message SMS:
WDOnTxxxxEa
where n is the output number, xxxx the time
in seconds and a the bus address.
NOTE
: you can set multiple outputs with one SMS when they have the same user defined ON or OFF
instruction.
In the following example Do1 is connected as normally open and Do4 is connected as normally closed.
Connect only to a single polarity supply! The following examples are not allowed:
10.3
GSM-PRO-10DI
The 10DI has 10 digital inputs. The following items can be configured for each input:
•
Name; default set as DI1 to DI10.
