Step 11: Attaching the LED wires.
• Now you will install the wires to control the Player 3 and 4 LEDs. Be sure to cut the wires to the exact length
needed and again keep the wires out of the black circles on the board..
• Solder the wire from Pin 9 to the bottom of the player 4 LED. You must be careful with this as the LED’s are very
fragile and leaving your soldering iron on the end to long could damage the LED. Only touch the very end of the
LED with your soldering iron. DO NOT touch the longer sides or the center of the LED because you will destroy it.
• Next Solder the wire from Pin 8 to the bottom of the Player 3 LED.
• The Left image shows the path your wires should follow and the right is a close-up of the LED’s
