![background image](http://html1.mh-extra.com/html/conrad/85-69-98/85-69-98_operating-instructions-manual_2653611026.webp)
26
Commissioning
There is a small slide switch on the back of the display. This can be used to switch off the beep signal or
adjust the beep signal volume as required (OFF = mute, LOW = normal volume, HI = loud)
Once the parking system is correctly installed and the display is connected, the system will turn on auto-
matically when reverse is engaged. A short acknowledging beep sounds as an activation check when the
signal is switched on and the display will come on.
Test the system prior to initial use to familiarise yourself with the displays and signals.
Ask a second person to simulate the “obstacle” behind your car.
To do so, switch on the ignition (on-board voltage supply) and then put the car into reverse.
Ask the second person to slowly advance towards the car from approx. 2 m away.
The distance can be read off directly in metres (3). At the same time, the direction of the obstacle will be
displayed with the small car icon.
The distance to an obstacle is signalled by a sound and speech signal. The following warning ranges must
be observed.
Distance
Range classification
Sound/Speech output
Display
200 cm
Safe range
Two metres
2.0
190 – 160 cm
Safe range
No signal
1.9 – 1.6
150 cm
Safe range
One point five
1.5
140 – 130 cm
Safe range
“Ding” signal
1-4 – 1.3
120 cm
Safe range
One point two
1.2
110 cm
Safe range
“Ding” signal
1.1
100 cm
Safe range
One metre
1.0
90 cm
Warning range
“Ding” signal
0.9 ATTENTION
80 cm
Warning range
Zero point eight
0.8 ATTENTION
70 cm
Warning range
“Ding” signal
0.7 ATTENTION
60 cm
Warning range
Zero point six
0.6 ATTENTION
50 cm
Warning range
“Ding” signal
0.5 ATTENTION
40 cm
Hazard range
Zero point four
0.4 ATTENTION
30 – 0 cm
Hazard range
Stop
0.3/0.0 STOP
Summary of Contents for 85 69 98
Page 59: ...59 ...