![background image](http://html1.mh-extra.com/html/conrad/64-64-24/64-64-24_operating-instructions-manual_2654370037.webp)
37
b) Integration of the "FS20 TC6" into an existing system
• To integrate the "FS20 TC6" into an existing FS20 system, first turn off the
operating voltage and wait 1 minute (the easiest option is to pull off the jumper
"J2").
• Then put the jumper "J1" into the position "Prog" and reapply the voltage (plug
"J2" on again correctly).
• To call up programming mode, press the keys "1" and "3" until the LED "D1"
blinks in one second intervals (approx. 5 seconds).
• Now you can enter the 8-digit house code of your present FS20 system with the
buttons "1" to "4".
After entering the last digit, the "FS20 TC6" automatically quits the programming
mode and LED "D1" goes off.
• You can assign each channel of the "FS20 TC6" a 4-digit code consisting of a
2-digit address group and a 2-digit sub-address.
To program the address, press the corresponding key pair of the desired
channel (e.g. for channel 1 the keys "1" and "2") for approx, 5 seconds until the
control LED "D1" blinks in intervals of seconds again.
Assignment of the desired address then takes place with the buttons "1" to "4".
After entering the last digit, the "FS20 TC6" automatically quits the programming
mode and LED "D1" goes off.
Of course, you can also perform the addressing if you want to use the
transmitter unit as a 6-channel transmitter.
In this case, first briefly press and hold the key to be programmed and then the
neighbouring key for at least 5 seconds simultaneously until the control LED
"D1" blinks.
With the keys "1" to "4", now enter the 2-digit address group and the 2-digit sub-
address as usual. The LED goes off after entering the 4-digit address.
If you do not want to make any more settings, return the jumper "J1"
to the position "Betr".
Summary of Contents for 64 64 24
Page 102: ...102 ...
Page 103: ...103 ...