![background image](http://html1.mh-extra.com/html/conrad/64-64-24/64-64-24_operating-instructions-manual_2654370039.webp)
39
If you do not want to make any more settings, return the jumper "J1" to the position
"Betr".
Attention!
Operation and programming with dual channel number differs from
normal operation!
Operation in case of dual channel number
Each key is assigned a different channel. The sending of a command is signalled
by the brief flash of the control LED.
Switching
A brief press of the key (less than 0.6 seconds) sends a switching command. The
addressed receiver changes its switching state from "off" to "on" or vice-versa.
Dimming
If you press a button for more than 0.6 seconds, the corresponding command for
dimming up/down is sent until you let go of the key again (lamp is dimmed up to
maximum and then dimmed down to minimum). Here, dimming also takes place in
the opposite direction of the previously sent command, meaning if the last
command was "dim up", the next press of the key dims the device down.
Timer programming in case of dual channel number
To program the timer function of a receiver, press and hold its allocated key on the
remote control while pressing the neighbouring key at the same time for 1 to 5
seconds (meaning key 1 longer than 1 second, but less than 5 seconds), then let
go and then also release the key you pressed first. Use this command to activate
and deactivate the timer programming.
For the actual programming steps, refer to the instructions in the corresponding
receiver manuals.
Summary of Contents for 64 64 24
Page 102: ...102 ...
Page 103: ...103 ...