![background image](http://html.mh-extra.com/html/conrad/1484607/1484607_operating-instructions-manual_2654583014.webp)
14
The four control channels that are displayed are assigned to the following functions:
CH1: Roll function
CH2: Nod Function
CH3: Pitch function
CH4: Tail function
Attention!
If the power supply is no longer sufficient for a faultless operation of the transmitter (less than 4 V), the LED
display (see figure 1, item 2) flashes and the transmitter emits short alarms at regular intervals.
In this case, terminate flight operation of the model immediately and insert a new set of batteries in the
transmitter or charge the transmitter batteries again.
Important:
If the remote control emits signals in a quick sequence after activation and the display shows neither the
operating voltage nor the control stick display, the control stick for the pitch function is not in the bottom
position or the transmitter does not properly recognise the position of the control stick. In this case, the
control sticks must be re-calibrated.
For more information on calibration of the control sticks, see the following chapters.
c) Adjustment of the Control Sticks
You can adjust the length of the control sticks, depending on
your steering habits.
To do so simply hold the bottom part of the grip (1) and turn the
upper part (2) up anti-clockwise.
You can now set the length of the control stick by turning the
bottom part of the grip.
Finally, tighten the upper part of the grip back up.
Figure 6