12
9. Setting up the Transmitter
In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries/Rechargeable Batteries
The power supply of the transmitter requires 4 mignon batteries (e.g. Conrad item no. 652506, please order 4 x) or 4
mignon rechargeable batteries.
Proceed as follows to insert the batteries/rechargeable batteries:
Lift the battery compartment lid (see figure 2, item 18) at the
lower edge and fold it up.
Insert four mignon batteries or mignon rechargeable batteries
into the battery compartment according to the indications at
the bottom (1) in the correct polarity. The spiral-shaped spring
contact (2) always must be connected to the minus pole of the
battery or rechargeable battery (3).
Then fold down the battery compartment lid and let it latch.
b) Switching on the Transmitter
Move the control stick for the pitch and tail functions (also see
figure 1, item 13) right to your body or to the bottom position.
Slide the on/off switch (also see figure 1, item 10) from the
lower switch position (off) up to the upper position (on).
Then the remote control transmitter emits two short signal
sounds, the LED (also see figure 1, item 2) lights up and the
backlit display (also see figure 1, item 9) shows the operating
display.
Attention!
If the control stick of the pitch and rail functions (also
see figure 1, item 13) is no longer in the bottom-most
position, the transmitter emits acoustic warnings in a
quick sequence.
To save power, the backlighting of the display is
switched off after approx. 8 seconds.
Figure 3
Figure 4