www.conquerordoors.com
9
S
W
-
W
A
L
L
P
H
O
T
O
A
L
-
I
N
A
L
-
S
P
K
XT4
S
W
-
W
A
L
L
P
H
O
T
O
A
L
-
I
N
A
L
-
S
P
K
XT4
S
W
-
W
A
L
L
P
H
O
T
O
A
L
-
I
N
A
L
-
S
P
K
XT4
RED
BLACK
-
B
A
T
T
E
R
Y
+
XT6
open or close the door as damage may occur to the trolley or carriage
5
Accessory installation
6.1
photo beam installation
The Photo beam is an infrared LED safety device. If a person or obstacle
interrupts the infrared beam when door closing, the opener will
automatically return to the open position.
6.1.1
Location of photo beam installation
As Fig. 26
：
Fix the photo beam brackets into the left and right walls on
the outside of the vertical tracks.
Then, install the photo beam units onto the brackets with M6×30 screws.
Notice
：
make sure the beams are placed at the same height and are level
6.1.2
Wiring
Remove the opener cover as per Fig. 27, and connect the two wires
to either terminals on each of the photo beams and the other end of
each two wires to the opener terminals marked with “PHOTO”.
NB
：
Please set the photo beam setting to 1
”
or
“
2
”
in the
set up menu on the auto to activate the beams.
6.2
Wall button installation
Wall switch must be installed on the place that can
clearly see the operation of the door and must be 1.3m
above the ground to prevent the children from mal-operation.
Open opener cover as Fig. 28, then connect two wire connecting
terminals. In the back of wall switch with the two terminals in the
opener marked with
“
SW-WALL
”
. Then fix the wall switch
to the wall with screws.
6.3
alarm installation
Opener can connect with alarm. If the door is open manually when the
opener is close, the alarm will keep beeping for 1 min. Pressing wall
switch or transmitter can delete beeping.
Connect wires according to Fig.29 and refer to the alarm manual about
the detailed alarm installation and adjustment.
Notice
：
Please ensure the alarm switch can be pressed when door is closed
.
6.4
back-up battery installation
Opener can connect with back-up battery (optional). The battery can be
charged by opener power. When power failure, the opener will
Turn to battery power supply automatically.
The battery is DC24V maintenance- free lead acid storage
Battery or two DC 12V batteries. Please refer to Fig. 30
7
Maintenance and repair
Please inspect the automatic reversal and the door balance monthly, and adjust it if necessary.
8. Technical data
a)
Max. output power
：
250 W
Fig. 26
Fig. 27
Fig. 28
Fig. 29
Fig. 30
