background image

www.connects2.com

3

Connects2

Vision

INSTALLATION

1. Before installation, cut the loop on the camera to enable/disable camera 

features.

 

Loop Cut 

-  

Lines On

 

Loop Uncut

 - 

Lines Off

6. Focusing now on the Camera Wiring Harness, connect the 

Black

 wire to a 

suitable ground connection. Connect the 

Red

 wire to a sw12V supply. 

Then finally connect the 

Yellow

 RCA to the Head Units source of video input.

3. Connect the Power Adapter to the Extension Cable and begin to thread the 

length toward the vehicles head unit.

4. Connect the flying wire found on the Extension Cable to a reverse trigger 

signal (this can normally be found within the reverse light circuit).

2. Select a suitable location for the camera and ensure that the area is free 

from any/all cabling, fuel or oil. Where possible, avoid locations subject to road 

dirt and water spray.

5. Connect the Extension Cable to the main Camera Wiring Harness.

7. To test the camera connection, turn on the ignition and put the vehicle into 

reverse. The camera feed will populate on screen with parking guidelines (if 

loop has been cut). 

If camera feed is unresponsive, please uninstall the wiring and reinstall carefully 

in accordance with the above steps

For further help and support, please contact us directly at 

support.connects2.com/tickets/technical 

and fill out a support ticket with the full details of your issue.

Reviews: