DX-1S DIGITAL PABX - MFC98 Manual
4-4
4.5
COM PORT SETTING OF MFC98 PC INTERFACE CARD
The MFC98 PC interface card acts as a special COM port card to communicate with the DX-1S digital
PABX. It is recommended to configure the MFC98 PC interface card to IRQ = 7, Address = COM4
(02e8). This is also the factory default setting of the PC Interface Card.
After inserting the card to PC, it also requires adding the COM port in Windows 98 Control Panel.
In Control Panel select Add New Hardware then follow the instruction to complete the installation.
(Detailed information about adding new hardware in Windows 98 please refers to Windows 98 manuals).
It is recommended to check any hardware conflict after adding the COM port.
4.6 SOFTWARE
SETUP
1.
Exit all open applications and insert the MFC98 installation disk 1 into floppy drive.
2.
Click the
START
button and select
RUN
3.
Type your floppy drive letter, followed by
:\setup
4.
Follow the on-screen instructions to complete the MFC98 installation.
4.7
BEST SCREEN RESOLUTION
It is recommended to use 640 x 480 or 800 x 600 screen resolution for MFC98, otherwise it cannot display
in full screen mode. It is also recommended to use small fonts for best visual effect.
4.8
CONSOLE CONFIGURATION FILE
MFC98 software requires an initialization file, SETUP.INI which is a plain text file containing the setting
of MFC98 program. So, it is required to check / change the SETUP.INI file before the first execution of
the MFC98 program. The passwords in the SETUP.INI file should be modified by MFC98 SETUP MODE
and the other items should be modified by a text editor. The SETUP.INI file is located at the MFC98
program directory or user can edit it by click on SETUP in the START | PROGRAM | MFC98.
If the file is not existing, MFC98 will use its default value for operation. For connecting MFC98 via RIM-
1S, this file must exist. The following table shows the fields and their description in SETUP.INI.
Item
Description and Setting
SMDR_SAVE_PATH
The path for saving SMDR. (This path is under the MFC98
program path).
SMDR_ON_MONITOR
Value=ON
SMDR will display on screen in SMDR Display
Mode
Value=OFF
SMDR will not display on screen in SMDR
Display Mode
CONSOLE_ID
Console ID when MFC98 start
COM_PORT
Value=1
COM1 (PC connects Modem or RIM-1S).
Value=2
COM2 (PC connects Modem or RIM-1S).
Value=4
COM4(use PC interface card).
CONSOLE_MODE
Value=0
MFC98 with PC interface card.
Value =1
MFC98 connects RIM-1S via serial port (Local
Mode).
Value=2
MFC98 connects RIM-1S via Modem (Remote
Mode).
MODE_INITIALIZATION
Modem Initialization Command.
(For detail about modem command, please refer to modem
manual).
MODEM_CONNECT
Modem Dialing / Connect command.
Table 4-3 DESCRIPTION OF SETUP.INI
