DX-1S DIGITAL PABX - MFC98 Manual
4-2
•
Hardware Console I.D. Setting
Switch 1 ~ 4 are the hardware Console I.D. of this card. If more than one MFC98 PC interface cards are
connected to DX-1S, all of the MFC98 card should have different I.D.
Remark: The Console Service Status of the selected console I.D. in DX-1S (Programming item 118) must
be set to 1 for proper MFC98 operation.
Default setting is switch 1 ~ 4 = OFF (I.D. = 0).
Switch Setting
Switch Setting
1
2
3
4
Console
I.D.
1
2
3
4
Console
I.D.
OFF
OFF
OFF
OFF
0
ON
OFF
OFF
OFF
8
OFF
OFF
OFF
ON
1
ON
OFF
OFF
ON
9
OFF
OFF
ON
OFF
2
ON
OFF
ON
OFF
10
OFF
OFF
ON
ON
3
ON
OFF
ON
ON
11
OFF
ON
OFF
OFF
4
ON
ON
OFF
OFF
12
OFF
ON
OFF
ON
5
ON
ON
OFF
ON
13
OFF
ON
ON
OFF
6
ON
ON
ON
OFF
14
OFF
ON
ON
ON
7
ON
ON
ON
ON
15
Table 4-2 DIP SWITCH CONSOLE I.D. SETTING
•
MFC98 Mode
Switch 5 must set to ON for using with MFC98 Console software.
Default setting: ON (MFC Mode)
•
COM port and interrupt selection
Switch 6 and 7 are for interrupt selection, so that either one should be set to ON. Switch 6 = ON is using
IRQ 7 and switch 7 = ON is using IRQ5
Switch 8 is COM port address selection. ON = 2F8 (COM3) and OFF = 2E8 (COM4).
Default setting: 6 = ON, 7 = OFF, 8 = OFF. (COM4, IRQ7)
4.3
OLD MFC-1S PC INTERFACE CARD INSTALLATION
MFC-1S PC interface card is the former version of MFC98 interface card and MFC-1S PC interface card
can also work with MFC98. When using MFC-1S PC interface card with MFC98 console software, ALL
console service status in DX-1S (programming item 110) must set to 1. Beside the slightly difference in
hardware setup, the PC station hardware requirement and MFC98 setup procedure are the same.
•
Setup Hardware Interrupt Level (JP1, the jumper block to set interrupt level).
•
The default hardware interrupt level (IRQ) is 7; PIN1, PIN 2 and PIN 6 are shorted.
