Copyright
©
2015
congatec
AG
IA30m10
17/82
4.1
Cooling Installation
Assembly Instruction:
•
Flip over the SBC and locate the position of the CPU
•
Place retention frame on the bottom side of the board with insulating foil facing the PCB and standoffs inserted to PCB mounting holes.
•
Remove the heatspreader's protection pull tab foil from the phase changer and carefully place the heatspreader to the CPU.
•
Insert assembling screws.
•
Hold the heatspreader with one hand so that it does not tilt while tightening the screws.
•
Slightly tighten each of the 4 screws so that they hold the heatspreader in place. To do so, start with one screw and then slightly tighten the
other screws in a crossover pattern. All the while keep holding the cooling adapter straight with one hand.
•
Now you can fully tighten the screws. Once again start with one and then continue to tighten the other screws in a crossover pattern. All the
while keep holding the cooling adapter straight with one hand
Caution
congatec cooling solutions have been specifically designed for use within commercial temperature ranges (0° to 60°C) only. It is the responsibility
of the end user to design an optimized thermal solution that meets the needs of their application within the industrial environmental conditions
it is required to operate in. Attention must be given to the mounting solution used to mount the cooling solution and SBC into the system
chassis.
