Copyright
©
2014
congatec
AG
TA30m16
14/95
Note
The conga-TCA3 supports only DDR3L memory modules. The memory modules in the sockets must be symmetrical - that is, same raw cards
and same memory sizes. Therefore, do not use different memory modules in the memory sockets. Doing so may cause system instability or
memory errors. Also make sure the memory modules support the data transfer rate of the particular variant.
In addition, when using one memory socket, insert the memory module only in the first memory slot on the conga-TCA3 (top side). If the first
memory slot is empty, the SoC will ignore the second memory socket (bottom side). When this happens, the conga-TCA3 will not turn on. See
the Intel's Bay Trail datasheet for more information.
2.2
Supported Operating Systems
The conga-TCA3 supports the following operating systems
•
Microsoft
®
Windows
®
7, 8, 10 (64-bit)
•
Microsoft
®
WES
®
7/8
•
Microsoft
®
WEC
®
7/2013
•
Linux (Timesys Fedora 18)
Note
The conga-TCA3 requires a minimum storage capacity of 16 GB (32-bit) or 20 GB (64-bit) for Windows 7/8/10 installation. congatec will not
offer installation support for systems that do not meet the minimum requirement.
2.3
Mechanical Dimensions
•
95.0 mm x 95.0 mm (3.75” x 3.75”)
•
Height approximately 18 or 21 mm (including heatspreader) depending on the carrier board connector that is used. If the 5mm (height)
carrier board connector is used then approximate overall height is 18 mm. If the 8 mm (height) carrier board connector is used then
approximate overall height is 21 mm.
