Command Reference Manual
Conexant
1118
4-6
Result Codes
CONNECT
Reported when the modems begins the training sequence after receipt of a valid <mod> value.
ERROR
If the modem’s transmit buffer becomes empty and the last transmitted character is NUL (00), the
modem continues to transmit NULs until the DTE sends more data or five seconds elapses. After five
seconds elapse with a empty transmit buffer, the modem will turn off the transmit carrier, return to the
command state, and report the ERROR result code.
OK
If the modem’s transmit buffer becomes empty and the last transmitted character is was not NUL, the
modem will turn off the transmit carrier, return to the command state, and report the OK result code.
Reporting Current or Selected Values
Command:
+FTM?
Response:
+FTM: <mod>
Example:
+FTM: 98
For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command:
+FTM=?
Response:
+FTM: (<mod> range)
Example:
+FTM: 3,24,48,72,73,74,96,97,98,121,122,145,146
4.2.2.5 +FRM - Receive Facsimile
This command causes the modem to enter the receiver mode using the modulation defined below.
Syntax
+FRM=<mod>
Defined Values
<mod>
Decimal number corresponding to the selected modulation mode and data rates shown in Table 4-2.
Reporting Current or Selected Values
Command:
+FRM?
Response:
+FRM: <mod>
Example:
+FRM: 98
For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command:
+FRM=?
Response:
+FRM: (<mod> range)
Example:
+FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes
CONNECT
Reported when the selected carrier is detected.
+FCERROR
Reported if another carrier is detected and FAR=0; the modem then returns to the command state.
NO CARRIER
Reported if loss-of-carrier is detected.
OK
Reported if the DTE sends any character to the modem other than XON or XOFF while operating in
configured flow control from the DTE; the modem then returns to the command state.
Summary of Contents for H08-15350
