Conexant H08-15350, Reference Manual

Page: 50 / 120

Command Reference Manual
Conexant
1118
3-32
Reporting Supported Range of Parameter Values
Command: +DR=?
Response: +DR: (<value> range)
Example: +DR: (0,1)
+DR: <type> Intermediate Result Code
The +DR: <type> reported represents the current (negotiated or renegotiated) modem-modem data compression type. If
enabled, the intermediate result code is transmitted at the point after error control negotiation (handshaking) at which the
modem has determined which data compression technique will be used (if any) and the direction of operation. The +DR
intermediate result code, if enabled, is issued after the Error Control Report (+ER) and before the final result code (e.g.,
CONNECT).
The format of this result code is:
Result Code Syntax
+DR: <type>
Defined Values
<type> An alphanumeric code corresponding to the selected option:
NONE Data compression is not in use.
V42B V.42bis is in use in both directions.
ALT MNP 5 compression.
Example
+DR: V42B
3.2.6.3 %C - Enable/Disable Data Compression
Enables or disables data compression negotiation. The modem can only perform data compression on an error corrected link.
Syntax
%C[<value>]
Defined Values
<value> A decimal number corresponding to the selected option:
0 Disables data compression.
1 Enables both V.42 bis and MNP 5 data compression.
2 Enables both V.42 bis and MNP 5 data compression.
3 Enables both V.42 bis and MNP 5 data compression. (Default.)
Result Codes:
OK <value> = 0, 1, 2, or 3.
ERROR Otherwise.