Conexant H08-15350, Reference Manual

Page: 36 / 120

Command Reference Manual
Conexant
1118
3-18
* The 'star' digit (tone dialing only).
# The 'gate' digit (tone dialing only).
+
! Flash: the modem will go on-hook for a time defined by the value of S29. Country requirements may
limit the time imposed.
@ Wait for silence: the modem will wait for at least 5 seconds of silence in the call progress frequency
band before continuing with the next dial string parameter. If the modem does not detect these 5
seconds of silence before the expiration of the call abort timer (S7), the modem will terminate the call
attempt with a NO ANSWER message. If busy detection is enabled, the modem may terminate the
call with the BUSY result code. If answer tone arrives during execution of this parameter, the modem
will handshake.
$ Wait for credit card dialing tone before continuing with the dial string. If the tone is not detected within
the time specified by S7 or S6, the modem will abort the rest of the sequence, return on-hook, and
generate an error message.
& Wait for credit card dialing tone before continuing with the dial string. If the tone is not detected within
the time specified by S7 or S6, the modem will abort the rest of the sequence, return on-hook, and
generate an error message.
, Dial pause: the modem will pause for a time specified by S8 before dialing the digits following ",".
; Return to command state. Added to the end of a dial string. This causes the modem to return to the
command state after it processes the portion of the dial string preceding the ";". This allows the user
to issue additional commands while remaining off-hook. The additional commands may be placed in
the original command line following the ";" and/or may be entered on subsequent command lines.
The modem will enter call progress only after an additional dial command is issued without the ";"
terminator. Use "H" to abort the dial in progress, and go back on-hook.
^ Toggles calling tone enable/disable: applicable to current dial attempt only.
( ) Ignored: may be used to format the dial string.
- Ignored: may be used to format the dial string.
<space> Ignored: may be used to format the dial string.
3.2.3.2 T - Set Tone Dial Default
This command forces DTMF dialing until the next P dial modifier or P command is received. The modem will set an S-
Parameter bit to indicate that all subsequent dialing should be conducted in tone mode. Note that the DP command will
override this command. Clears S14 bit 5.
This command may not be permitted in some countries. (See P.)
Syntax
T
Result Codes
OK