43
PDV 7160
EN
CLEANING AND MAINTENANCE
Allow the appliance to cool prior to any cleaning or maintenance procedures.
Never use steam or pressure-cleaning machines!
Maintenance
Preserve the base using a proper protective agent. The dirt-resistant coating can facilitate cleaning.
Cleaning
Clean the appliance after every use. Food residue may be burned or ignite during the next use! Clean the warm
base using a paper towel and warm water with detergent. Then wipe the base with a damp cloth and dry using
a soft cloth.
Improper
Never use
coarse sponges, abrasive cleaners or caustic agents such as oven cleaner or stain remover.
Control panel
Keep the panel clean and dry.
Food residues and food that has boiled over may affect the performance of the controls.
Burner
If water or liquid that has boiled over enters the burner, allow the burner to cool. Then remove the grate, burner
cap and flame diffuser (Fig. 2) and clean all the parts. You can dip them in warm water with detergent and use
a fine brush to clean them. Dry every part well before installation.
UNIT INSTALLATION
• Only the customer, not the manufacturer, is responsible for installation. Defects caused by incorrect installation
are not covered by the warranty.
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• Install the appliance in a properly ventilated room only! For the required ventilation dimensions see Fig. 5.
• To ensure correct function of the unit, install it in suitable furniture.
• The unit should be installed in standardized kitchen furniture designed for built-in appliances or in properly
adapted furniture of the dimensions indicated below.
• The kitchen furniture must be made of sufficiently heat-resistant material. Materials and adhesives used must
be resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that do
not meet the stated standard may deform or loosen.
• The back wall behind the appliance must be made of heat-resistant material (min. 120°C min.).
• The appliance should not be installed close to a kitchen cabinet made of flammable materials and overreaching
the worktop.
