157
EN
MN3360ss / MN3360wh
Connection of the water supply
• Before connecting the inlet hose to the water supply,
make sure that the water pressure is in the range of 0.04
to 1.00 MPa. When water pressure is higher, you must
install a pressure reducing valve.
• Connect the inlet hose to the tap with 3/4“ thread
(Fig. 18). Make sure that the inlet hose is not bent,
crushed or entangled.
• When replacing the appliance always use
a new inlet
hose
!
• If the water pipes are new or they have not been used
for a longer period of time, run off a sufficient amount of
water before connecting the inlet hose to rinse the pipes
and wash away any impurities.
• If these safety instructions are not observed, it may lead
to blockage and damage to the appliance.
Connection to the mains
•
Make sure the mains voltage and current protection correspond to the values on the rating plate of the
appliance. We recommend using a separate outlet with a 10A circuit breaker.
•
Only use grounded sockets.
•
Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
•
The plug of the power cord on the appliance must be freely accessible even after the installation.
•
Changes in a connection may only be performed by a qualified professional.
•
Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected
to the protective conductor of the mains.
•
The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad
protective connection.
Fig. 18
B
A
Water supply
Dishwasher
back
Drain
Ø 40 mm
max 1 000 mm
Kitchen top
Drain hose
Power cord
Fig. 17
Safety supply hose
Common supply hose
Connecting the drain hose
Connect the drain hose to the waste pipe with a minimum diameter: 40 mm (Fig. 18). Make sure the drain hose is not
bent or squeezed to prevent slowing down or stopping of the water flow.
The height of the waste pipe must be less than 1,000 mm (Fig. 18) and the drain hose should not be submerged in
water. Secure the drain hose properly to prevent unwanted loosing from the waste pipe.
Summary of Contents for MN3360ss
Page 2: ......
Page 34: ...34 MN3360ss MN3360wh CZ ...
Page 67: ...67 SK MN3360ss MN3360wh ...
Page 133: ...133 LV MN3360ss MN3360wh ...
