Concept2 MN3360ss, Manual, Page: 142 / 168

142
EN
MN3360ss / MN3360wh
Note:
• The regenerating salt container is located under the lower rack.
• The regenerating salt container can be refilled only when the salt status indicator is on.
• After refilling the indicator goes off.
• If there is a spillage of regenerating salt, run a short washing cycle to wash away the salt.
Caution!
• Load the regenerating salt before running washing cycle to wash away any spilled salt residues and prevent the
risk of corrosion of the appliance interior.
• Always use regenerating salt designed for use in dishwashers. Never use table salt!
• Never pour detergents into the regenerating salt container. Detergents can destroy the softening unit!
In the event of damage caused by improper use of salt, the manufacturer assumes no responsibility or
liability for any caused damage.
LOADING THE RINSE AID
The rinse aid is used in the last stage of rinsing to prevent the drops of water from staying and drying out on the
dishes leaving undesirable stains on the dishes.
1. Open the appliance door.
2. Open the rinse aid dispenser as shown in Fig..3.
3. Slowly pour the rinse aid into the dispenser (Fig.. 4). The capacity of the empty dispenser is about 140 ml.
4. After filling close the rinse aid dispenser cover and tighten it (Fig.. 5).
Fig.3 Fig.4 Fig.5
If the indicator of the amount of the rinse aid lights up, you must refill the dispenser before starting a new washing
cycle!
Note:
• The rinse aid dispenser is located on the door next to the detergent dispenser.
• The appliance is designed to be used only with liquid rinse aids.
• If there is a spillage of the rinse aid, wipe it out using an absorbent cloth or run a short washing cycle to wash it
away.