Thermolator TW Series
UGH025-0504
6-4
T
ROUBLESHOOTING
A status light
that turns from
green to red
indicates an alarm
condition.
Most Thermolator malfunctions are indicated by an illuminat-
ed alarm light and error codes displayed on the control panel.
A problem can trigger three types of alarms:
l
Shut Down Alarms:
The Thermolator detected a problem
that caused it to shut down automatically to prevent equip-
ment damage or personal injury.
l
Warning Alarms:
The Thermolator continues to operate,
but warns of a problem that could lead to a condition that
will shut down the unit.
l
System Errors:
The system error codes indicate a non-
recoverable problem with the microprocessor control.
When the Thermolator control detects a problem, the red
Alarm light is activated and the RUN/STOP light changes
from green to flashing red.
I
DENTIFYING THE
C
AUSE OF A
P
ROBLEM FOR
THE
TW-1, TW-
2 C
ONTROL
WARNING:
Disconnect and lockout
the main power source
before opening the
Thermolator or its electri-
cal enclosure for servic-
ing. Disconnect air and
water supply lines as
needed.
When an Alarm condition occurs:
Press to silence any optional audible or
visual alarm. The RUN/STOP light changes from flashing
red to steady red.
Note any indicator lights or error messages to
help determine the cause of the problem.
Find the alarm or error code in the diagnostics
tables in the Troubleshooting section of this manual.
If the unit is still operating, press to clear
the alarm and shut down the Thermolator to correct the
problem.
Press to resume normal operation after
the problem is corrected.
1
2
3
Stop
4
Run
5
Summary of Contents for Thermolator TW
