Plug in the power cord to restore power after any required
maintenance. The Chiller requires 15 minutes warmup time
after it is plugged in for the crankcase heater to warm up.
Turn on the main power.
The chiller control automatically performs its bootup rou-
tine. the screen displays the Portable Chiller model num-
ber along with the Enter command.
P
OWERING
U
P
Series 1 Portable Chillers, PLC Control
UGH017/0500
4-4
O
PERATION
Press the Scroll arrow to move
to the Main screen.
Conair Chiller
A1 - 5
1
2
STATUS SETUP RUN ALM
The main screen displays:
The main screen lets you:
●
view the status
of the water level, process temperature,
suction pressure, percent glycol, low temperature
cutout and discharge pressure.
●
view and change the setups
for temperature setpoint,
Auto tune mode, high temperature deviation, and per-
cent glycol solution
●
run or stop the chiller
●
view alarm information
●
perform maintenance with password clearance
Press the arrow pointing to the selection
you want displayed on the screen.
STATUS SETUP RUN ALM
Choose a selection
3
If you disconnect the Chiller
from the main power supply
and reconnect it, the Chiller
needs 15 minutes for the
crankcase heater to warm
up. You can not use the
Chiller during this time.
