![background image](http://html1.mh-extra.com/html/conair/a1-1-5/a1-1-5_user-manual_2649037033.webp)
UGH017/0500
Series 1 Portable Chillers, PLC Control
I
NSTALLATION
3-13
C
ONNECTING
THE
R
EMOTE
C
ONTROL
If your chiller has the optional remote interface, you need to
connect it to the chiller control. The chiller control panel is
hinged on the bottom. Pull down on the top of the outer bezel
of the control to expose the internal wiring. Plug the interface
cable from the remote controller into the communication cable
connection.
Communication
connection
S
TOPPING THE
C
HILLER
To stop the chiller, press the Stop Chiller button on the control
panel.
The compressor shuts off after a few seconds and the pump
shuts off a few seconds later. This allows the chiller to pump
down the refrigerant system and store the refrigerant in the
receiver. This prolongs the life of the chiller.
NOTE: If you want to restart the chiller immediately after
stopping it, pressing the Run arrow on the display starts the
pump (the Process Pump light on the control panel lights) but
the compressor will not turn on for three minutes. After three
minutes the compressor turns on and the Compressor light on
the control panel lights. This allows temperatures and pressure
to equalize, making restart easier, and prolonging the life of
the chiller.
If the chiller is not working properly at any time, stop the
chiller and refer to the Troubleshooting section. If you do not
encounter any problems, proceed to the Operation section.