![background image](http://html.mh-extra.com/html/conair/18-series/18-series_user-manual_2649458084.webp)
7
Fasten the knife with the socket cap screws and the support rules furthermore
with an alternated increased torque to 600 Nm.
Then install fixed knife no. 4 (option)
The fourth fixed knife is installed in exactly the same way as the front fixed knife,
the front fixed knife no. 2. Read and follow the above description.
Install the fifth fixed knife (option)
1
Install one support rule
together with one knife
at a time.
Fit the socket cap screws
so that the support rule
lightly hold the knife.
The socket cap screws
which fasten the support
rules and the fixed knife pair, are fitted from underneath the front
of the cutter housing.
2
Fasten the knife with the socket cap screws and the support rules and tighten
with an alternated increased torque to 200 Nm.
3
4
Fasten the knife with the socket cap screws and the support rules furthermore
with an alternated increased torque to 400 Nm.
NOTE:
Knock/hammer between the alternately increasing tightening torque with the
plastic or rubber mallet, so that the knives firmly goes down and in to the rear of the
knife position.
5 Fasten the knife with the socket cap screws and the support rules furthermore
with an alternated increased torque to 600 Nm.
NOTE:
Use a plastic or rubber mallet and knock/hammer
the knives hardly down and in against the rear of the knife
position.
Fixed knife no. 5 (lower)
7 . 1 K n i f e c h a n g i n g
( c o n t i n u e d )
7
S
e
rv
ic
e
S e r v i c e l
7 - 1 3