Two hours after first start
The screws tightening torque to the fixed knife no. 1 (rear) have been re-checked
. . . . . . . . . .Nm.
The screws tightening torque to the fixed knife no. 2 (front) have been re-checked
. . . . . . . . . .Nm.
The screws tightening torque to the rotating knives have been re-checked
. . . . . . . . . .Nm.
The screws tightening torque to the fixed knife no. 3 have been re-checked
. . . . . . . . . .Nm.
The screws tightening torque to the fixed knife no. 4 have been checked
. . . . . . . . . .Nm.
The screws tightening torque to the fixed knife no. 5 have been checked
. . . . . . . . . .Nm.
Knife clearance re-checked, knife clearance at the knives outer sides . . . . . . and the knives center . . . . . . .
The screws tightening torque which hold the granulator motor to the motor mounting bracket . . . . . . . . Nm.
The nuts on the adjusting screws which hold the motor mounting bracket setting
are counter-tightened checked . . . . . . . . Nm.
Inspection done by Date: . . . . / . . . 20 . . . . .Name: . . . . . . . . . . . . . . . . . . . . . . . . .
20 - 30 hours after first start
The drive belt condition have been checked.
The drive belt tension have been checked. The drive belt tension have been adjusted.
The screws tightening torque to the upper bracket of the jack against the hopper checked
. . . . . . . .Nm.
The screws tightening torque to the lower bracket of the jack against the stand checked
. . . . . . . .Nm.
The screws tightening torque to the hopper against the rear hinge checked
. . . . . . . .Nm.
The screws tightening torque to the which holds the locking rule to cutter house door checked . . . . . . .Nm.
The cutter housing stands horizontally and the stands all machine shoes takes up load.
General inspection OK.
Inspection done by Date: . . . . / . . . 20 . . . . .Name: . . . . . . . . . . . . . . . . . . . . . . . . .
1 3 - 4
l S e r v i c e a n d M a i n t e n a n c e S c h e d u l e
