SMS-758 Modem Protection Switch
Remote Control Operation
MN/SMS758 Rev. 3
A–13
A.3.5.5.3 Load Backup Modem Configuration
Command:
<add/LMC_Bx”cr”
Response:
>add/LMC_Bx”cr”
MOD_Bx_yyy”cr”
DMD_Bx_yyy”cr””lf”]
Where:
x = 1 or 2 (backup modem number).
yyy = OK or FLT.
A.3.5.6 Verify Modem Configuration(s)
These commands tell the switch to poll the specified modem(s) for configuration
information (via the modem remote control serial communications link). The received
configuration(s) are compared to the last loaded configuration(s).
A.3.5.6.1 Verify All Active Modems Configurations
This command verifies all the active modems configurations and returns status.
Command:
<add/VMC_ALL”cr”
Response:
>add/VMC_ALL”cr”
MOD_1_yyy”cr”
DMD_1_yyy”cr”
MOD_2_yyy”cr”
DMD_2_yyy”cr”
MOD_3_yyy”cr”
DMD_3_yyy”cr”
MOD_4_yyy”cr”
DMD_4_yyy”cr”
MOD_5_yyy”cr”
DMD_5_yyy”cr”
MOD_6_yyy”cr”
DMD_6_yyy”cr”
MOD_7_yyy”cr”
DMD_7_yyy”cr”
MOD_8_yyy”cr”
DMD_8_yyy”cr”
MOD_B1_yyy”cr”
DMD_B1_yyy”cr”
MOD_B2_yyy”cr”
DMD_B2_yyy”cr””lf”]
Where: yyy = OK or FLT.
Note: Response shown is for a system with all possible modulators and demodulators
active. Only active modulator and demodulator configurations will be verified and
reported.
