Comtech EF Data SDM-9000, Installation And Operation Manual

Page: 241 / 256

SDM-9000 Satellite Modem Remote Control Operation
Rev. 4 B–23
Bulk Consol.
Status
(continued)
Parameter
Number
Parameter Name
(Command Reference)
Description
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Demodulator preset A
assignment
(ref. 'ADRA_' command).
Demodulator preset B
assignment
(ref. 'ADRB_' command).
Demodulator preset C
assignment
(ref. 'ADRC_' command).
Demodulator preset D
assignment
(ref. 'ADRD_' command).
Differential decoder enable
(ref. 'DDEC_' command).
RF loopback
(ref. 'RFL_' command).
IF loopback
(ref. 'IFL_' command).
BER threshold
(ref. 'BERT_' command).
Demodulator Spectrum Rotation
(ref. 'DSR_' command).
Reed-Solomon Decoder Enable
(ref. 'RSDE_' command).
External reference frequency
(ref. 'ERF_' command).
Transmit clock phase
(ref. 'TCP_' command).
Receive clock phase
(ref. 'RCP_' command).
Baseband loopback
(ref. 'BBL_' command).
Interface loopback
(ref. 'ILB_' command).
Interface loop timing
(ref. 'ILT_' command).
TX Interface coding format
(ref. 'ICFT_' command).
RX Interface coding format
(ref. 'ICFR_' command).
Scrambler enable
p17 = nnnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p18 = nnnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p19 = nnnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p20 = nnnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p21 = n, where 'n' is '0' (OFF) or '1' (ON).
p22 = n, where 'n' is '0' (OFF) or '1' (ON).
p23 = n, where 'n' is '0' (OFF) or '1' (ON).
p24 = xxxx, BER threshold.
p25 = n, where 'n' is '0' (NRM) or '1' (INV).
p26 = n, where 'n' is '0' (OFF), '1' (ON), or '2' (CORR_OFF).
p27 = nnnnn.nnn, external reference frequency in kHz.
p28 = n, where 'n' is '0' (NRM) or '1' (INV).
p29 = n, where 'n' is '0' (NRM) or '1' (INV).
p30 = n, where 'n' is '0' (OFF) or '1' (ON).
p31 = n, where 'n' is '0' (OFF) or '1' (ON).
p32 = n, where 'n' is '0' (OFF) or '1' (ON).
p33 = n, where 'n' is '0' (AMI), '1' (B3ZS), or '2' (HDB3).
p34 = n, where 'n' is '0' (AMI), '1' (B3ZS), or '2' (HDB3).
p35 = n, where 'n' is '0' (OFF) or '1' (ON).