3.5 Modifying the program
• The previously set program can be modified any time by repeating the
steps of programming.
• The number of activated switches can be increased at will as described in
Section 3.3
.
• A previously activated switch can be deactivated by setting its start time
to
using the large
and
buttons (or by pressing the “
DAY
”
button once), and then pressing the “
PROG
” button. After this, if the
deactivated switch was an intermediate one, then the serial numbers of
the remaining switches will be updated.
• If you wish to finish modifying the program of the selected day, then press
the “
PROG
” button and hold it down for at least 3 seconds. After this, the
modification can be continued by selecting another day. When finished
with all the modifications, press the “
SET
” button to save them. After
approximately 1 minute, they are automatically saved. Afterwards, the
device goes back to the main screen.
• If a completely different program is needed, then press the “
RESET
”
button located on the main panel of the thermostat to reset the device (it
deletes both the program and the basic settings). Following this, adjust
the basic settings of the thermostat again and create the new program, as
described in
Sections 2
and
3
.
3.6 Program inspection
• First, press the “
SET
” button to go to the main screen, then press the “
PROG
”
button. At this point, the abbreviation indicating the day(s), the symbol of
switch
PROG
and the time and temperature level set for switch
PROG
of the
selected day(s) will appear on the display (none of the values is flashing).
• Repeatedly press the “
PROG
” button to check the values of switch
PROG
,
PROG
, etc. Use the large
and
buttons to change the day(s). If
all the days were programmed together (
MON TUE WED THU FRI SAT SUN
),
then their common program can only be viewed together.
• After checking the program, press the “
SET
” button to go back to the main
screen (if no buttons are pressed for at least 15 seconds, the thermostat will
automatically go back to the main screen).
4. TEMPORARY MODIFICATION OF THE TEMPERATURE
CORRESPONDING TO THE PROGRAM
If you wish to operate your device in a way that differs temporarily from the
program that has been set (e.g. on bank holidays or the winter holidays), you
can choose among the options described in
Sections 4.1-4.4
.
To simplify manual temperature modifications, with factory default settings
temperatures of
°C and
°C
are assigned to the large
and
buttons, respectively. When modifying the temperature manually, pressing
the
and
button once, the temperature will immediately jump to the
- 11 -
