- 21 -
5.6.
If the switching threshold determined this
way is considerably lower than the maximum
grade of the gas heater we propose to
perform calibration of
KonvekPRO
. Turn the
regulating knob of the gas heater to (near)
the maximum grade. With a small (Phillip
head) watchmaker’s screwdriver, by reaching
through the calibration slot at the bottom of
KonvekPRO
, adjust the potentiometer clockwise
in very small increments and wait 4-5 minutes
after every adjustment so that the system is
stabilized to the new temperature. Turn the
potentiometer until the gas heater just cannot
switch on any longer at the set (near) maximum
temperature. After you have determined (and
set, if required) the switching threshold turn
the temperature regulating knob of your gas
heater to the next lower grade.
5.7.
The respond time of the system is
basically determined by the difference of
