- 9 -
2.6.
Place
KonvekPRO
onto the screws prepared on
the wall and, with a cautious vertical motion, fix
it in place. In case of correct installation
Konvek-
PRO
is seated stably against the wall surface.
2.7.
Connect the cable leading to the thermostat
to
KonvekPRO
. Put a thin two wire cable into
the thermostat connector located in the lower
part of
KonvekPRO
then tighten the fastening
screws with a small watchmaker’s screwdriver,
reaching through the holes on its top.
Several
KonvekPRO
can be combined and
connected to a single thermostat but in this
case you should ensure correct polarity: in
this case make sure that the right-hand side
cable of each thermostat connector located
on
KonvekPRO
s to be combined is connected
to the connector on the right side of the other
KonvekPRO
s while left cables are connected
only to left connectors.
2.8.
Install the thermostat (which is compatible only
