22
23
By default, all of the channels are active at the beginning of the session. To deselect a channel,
simply press the corresponding button.
Notes:
depending on the program, the diagram on the middle of the screen can change. There are
two types of diagram listed below.
Refer to above screenshot, In this case only channel 1 is active. Any change of intensity will only
be performed on channel 1.
INCREASE THE STIMULATION INTENSITIES ON THE SELECTED CHANNELS.
1. WORK PHASE/RELAXATION PROGRAM
These programs always begin with a warm-up phase. After this warm-up phase, a work cycles
phase followed by relaxation occurs (the number of cycles depends on the program) and when all
cycles are completed, the program ends with a recovery phase.
2. WARM UP, RECOVERY TYPE PROGRAM
These program consist of a single phase and have no work phase/relaxation cycle.
These are warm up, recovery, or even pain type program. During this type of program,
frequency variations can occur.
A.
Warm up phase
B.
Work phase
C.
Relaxation phase
D.
Recovery phase
E.
Work time phase which consists of work
phase and relaxation phase
A.
Work time phase
By pressing on the central confirmation button during stimulation, the device goes into pause. At
this point it is possible to skip the current phase or exit the program.
N.B.: The session restarts with intensities equal to 75% of those used prior to the interruption.
At the end of the session a screen with a check
mark appears. Pressing on the central confirmation
or right buttons return you to the home page. To
turn off the device, hold down the On/Off button
for 5 seconds.
F: CONTINUE A STIMULATION PROGRAM
G: END A STIMULATION PROGRAM
B
C
A
A.
skip the current phase. or
exit the program
B.
Resume the stimulation
session
C.
Skip the current phase. or
exit the program
