Compaq WL110, User Manual

Page: 135 / 144

Forced Reload Procedure C-3
■
Make sure the LAN administrator station and the Access Point are
connected to the same LAN segment (subnet).
To communicate with the Access Point in “Forced Reload” state, no routers
are allowed between the target Access Point and the LAN administrator
station.
■
When using IP addressing, write down the IP address that the Access Point
should use.
Your LAN administrator station is a Wireless Station
You can use a wireless LAN administrator station to access the Access Point in
force reload mode ONLY IF the station has indirect access to the Access Point,
as described on “Wireless Access via an Indirect Connection” on page 3-10.
Make sure that your LAN administrator station matches the settings of the
Access Point that you will use to establish the connection to in forced reload
mode.
■
Make sure the LAN administrator station is within range of the Access
Point.
When using IP addressing, write down the (new) IP address that you would like
to assign to the Access Point in forced reload mode.
Step 2 - Set to “Forced Reload” Mode
1. Remove the cover of the Access Point.
2. Locate the two small holes on the long-edge side of the processor module,
marked “Reset” (A) and “Reload” (B) (see Figure C-1).
Figure C-1 Reset and Reload Buttons
3. Use a small pointed object, such as the tip of a ball-point, to press the
Reset
button.
4. Release the
Reset
button and wait 5 seconds.
The Access Point will perform start-up diagnostics, characterized by LED
activity, where the LEDs will change color in the range Amber, Red and
Green.